Forum

Ron, I've never tried that. I would go into Raspi-config and manually define the username then leave the password blank and see if that works. Please ...

I'm sorry, I just saw this question: Be sure to check the number of LED's in the editor is set correctly. There are 2 places. One in the Airport edito...

To be clear, the LED's on the map work properly for European airports, but the weather that is displayed on the Airport editor shows UNDF for European...

Hi, disconnect everything from the RPi and with a monitor connected, reboot. If you see the software output showing that the software is working, then...

Mallock, you are describing the typical Ground Flash issue. Would you be able to take a few pictures of the wiring and post them here. We'll take a lo...

HI, sorry for the difficulties. I'll try to help any way I can. Let me know if you have a monitor and keyboard connected directly to your RPi. If s...

Hmm, the link to get the needed data works just fine. It returns the XML needed to light up your map. I notice you are running V4.501. It may be worth...

Interesting. I'll have to look at it more carefully, but I'm out of country, so it will be a while. I'm glad it's working though. - Mark

Hi, I'm sorry for the hassles. I will do my best to help. Based on the description of the issue, it sounds like the ground for the LEDs and Rpi are ...

Yes, its programmed to restart in the middle of the night for just this type of issue. The fact that the data from the FAA isn't rock solid is a pain,...

At times the FAA will not include some information that is needed. I try to error check for these situations but at times I'll miss one. In this case,...

Hi Ron, Whenever the power goes out then comes back on, the map boots up quicker than the internet router. So the map attempts to connect 10 times, ...

Thanks for letting me know its working properly. - Mark

Hi Ron, I put a new image together, V4.503 and Bill posted it to the downloads page. So give it a try and let me know if you still have the same iss...

Hi Ron, there was a small change to the call made to the FAA site where it will timeout if the FAA site doesn't respond properly. I'm guessing this is...