Forum

One final pic showing the small one mounted on the wall with some other pics of our travels.

@markyharris I have the print mounted and most of the light bushings installed. The PCB needs a few wires soldered especially the one with the multipl...

@markyharris I think it’s working as you describe. I guess my expectation was for the display to be static for 10 minutes and then update along with t...

@markyharris About every 30 seconds I see the OLED's go blank left to right and then the the update time shown, then the OLEDS, update to all 8 screen...

Regarding the 4 place OLED, my preference would be to not have them scrolling. I would like to see 4 exclusive airports on the left (0-3) and the high...

@markyharris In general I like the solderable board. It took some youtube videos to see the right way to use it, that is to fill the hole with solde...

Here is the completed map. I reworked the layout, added the 8 OLED displays and made some sleeves and button caps for the 3 buttons. The wood didn't d...

Please allow me to point out some specifics, I'm not contradicting Mark at all. The (black and red) power and ground wires, move them to the other r...

@markyharris Interesting. I think I did reboot the RPI but I'll pay attention next time. Thanks for the info.

I'm seeing a conflict between what the category is in the airports editor page and the map as shown. Foreflight is showing the airports as V...

Well you know this stuff inside and out, so that makes you a genius.